|
将FPGA配置数据和程序都写到EPCS1中,结果又失败了,错误信息如下:
Using cable "USB-Blaster [USB-0]", device 1, instance 0x00
Resetting and pausing target processor: OK
Reading System ID at address 0x00001838: verified
: Checksumming existing contents
00000000 : Verifying existing contents
00008000 : Verifying existing contents
00010000 : Verifying existing contents
00000000 : Reading existing contents
00008000 : Reading existing contents
00010000 : Reading existing contents
Checksummed/read 19kB in 2.0s
00000000 ( 0%): Erasing
00008000 (33%): Erasing
00010000 (66%): Erasing
Erased 96kB in 1.6s (60.0kB/s)
00000000 ( 0%): Programming
00008000 (33%): Programming
00010000 (66%): Programming
Programmed 78KB +18KB in 12.2s (7.8KB/s)
Did not attempt to verify device contents
Leaving target processor paused
# Creating .flash file for the project
"$SOPC_KIT_NIOS2/bin/elf2flash" --epcs --after="standard.flash" --input="hello_w
orld_0.elf" --output="epcs_flash_controller.flash"
# Programming flash with the project
"$SOPC_KIT_NIOS2/bin/nios2-flash-programmer" --epcs --base=0x00000000 --sidp=0x0
0001838 --id=1376933687 --timestamp=1257592090 "epcs_flash_controller.flash"
Using cable "USB-Blaster [USB-0]", device 1, instance 0x00
Resetting and pausing target processor: OK
Reading System ID at address 0x00001838: verified
: Checksumming existing contents
00010000 : Verifying existing contents
00010000 : Reading existing contents
Checksummed/read 15kB in 1.6s
00010000 ( 0%): Erasing
Erased 32kB in 0.5s (64.0kB/s)
00010000 ( 0%): Programming
Programmed 18KB +14KB in 3.9s (8.2KB/s)
Did not attempt to verify device contents
Leaving target processor paused
为什么会Did not attempt to verify device contents ?
希望大侠们指点一下啊,谢谢了 |
阿莫论坛20周年了!感谢大家的支持与爱护!!
知道什么是神吗?其实神本来也是人,只不过神做了人做不到的事情 所以才成了神。 (头文字D, 杜汶泽)
|