跪求个设计方案
本帖最后由 guoke1930 于 2014-2-22 17:15 编辑Assignment at the EWI/ICD-chair of the University of Twente
"Feeding Hot to be really cool"
Without food there is no life and with better food, you can perform better. This applies not only forwell performing people, but also for our high performance Integrated Circuits ( ICs).
Introduction
At ICD we design many ICs with such high performance that just measuring it is rather challenging . We do have quite expensive measurement equipment, able to measure very accurate up till very high frequencies. All external interferences and non-idealities have to be as small as possible for good measurements.
In the latest communication technologies we work with supply voltages of around 1 Volt, and these must be very stable and almost noise free. Only if we use a very good power supplywe can achieve and demonstrate the excellent specifications of our IC designs.
Batteries are basically good enough, but the voltage is difficult to regulate without a polluting electronic circuit. Additionally batterydischarge providing voltage drop which is rather annoying for prolonged use. Commercially hardly appropriate sources are available for these low voltages and certainly not with the desired specs we have….
Assignment
The purpose of this assignmentis to improve an already realized completely new type of power supply by investigating its drawbacks and do suggestions to overcome them. In the end an improved, very low noise, power supply have to be realized.
Description:
The proposed supply exists of two Peltier elements, that are thermally coupled to a hotplate to transfer heat energy in electric power. Furthermore a (PC) forced cooling with heat pipes is used to help regulating the output voltage of this supply. The basic idea to make use of Peltier elements is that they do have a low impedance and it is presumed that they will have little noise contribution. Higher frequency components will be filtered out by the large time constant of the temperature gradient.
Assignmentin a nutshell
Investigate, improve, re-design, characterize a better-than-state-of-the-art adjustable power supply source,“Peltier-based”, adjustable between 0 - 1.2 Volt,Pout = 200mW @1V, noise contributions approaching the battery level, computer controlled ...
帕尔贴_百度百科
帕尔贴是从英文“Peltier”一词翻译过来的，国内有多种名称，如制冷片，半导体制冷片，热电半导体致冷组件等。国内目前以 帕尔贴半导体（中国）有...
第一次看到这叫法 huangqi412 发表于 2014-2-22 16:51
帕尔贴_百度百科
帕尔贴是从英文“Peltier”一词翻译过来的，国内有多种名称，如制冷片，半导体制冷片，热 ...
那应该怎么叫啊 这翻译能再扯淡点么？
Batteries are basically good enough （电池基本上不够好）
adjustable between 0 - 1.2 Volt（可调0-12V）
hotplate（电炉）
话说回来，这assignment还是自己研究去吧，学术界的歪风不能助长。 本帖最后由 guoke1930 于 2014-2-22 17:16 编辑
gzhuli 发表于 2014-2-22 17:06
这翻译能再扯淡点么？
Batteries are basically good enough （电池基本上不够好）
adjustable between 0 - ...
好吧，BZ教训的是。还请BZ指点迷津啊。。。 guoke1930 发表于 2014-2-22 17:10
好吧，BZ教训的是。还请BZ指点迷津啊。。。
思路在另一贴已经说了啊，归根究底就是温控，你起码应该自己动手做了碰到难题再来问吧？
页:
[1]