照明 & 散热 —— AMCNC-02机
上面大风扇是干嘛的?吹走切削屑? 饭桶 发表于 2013-3-1 12:33 static/image/common/back.gif
上面大风扇是干嘛的?吹走切削屑?
人家标题就说了:“散热” 。 这么改法下去,快要面目全非了{:titter:} LDCH88 发表于 2013-3-1 14:54 static/image/common/back.gif
这么改法下去,快要面目全非了
感觉 PVC比铝密度大,上网一查
PVC密度:1.38~1.43g/cm3
铝在2.7左右;
本想把Z轴整体换了,减轻Z轴负担,现在看来,得想别的办法了 >PVC密度:1.38~1.43g/cm3
>铝在2.7左右;
So, aluminum is heavier than PVC. 还要考虑铝的强度比PVC高,达到同样强度所用的铝比PVC少。 >还要考虑铝的强度比PVC高
Any data to support the conclusion? 根据试验得知:
20℃时,PVC的抗拉强度在50Mpa左右,40℃时为40Mpa;
纯铝退火状态下,抗拉强度80Mpa左右;
铝合金,在200 — 600Mpa的范围内;
当然,真正机械设计着重考虑的是屈服强度或规定非比例延伸强度,可以参考(最大)抗拉强度,单纯这样看的话,铝合金胜出; >铝合金胜出;
So, after finished the adjustment of the z-axle, how do you like the 02 machine? funnynypd 发表于 2013-3-4 10:13 static/image/common/back.gif
>铝合金胜出;
So, after finished the adjustment of the z-axle, how do you like the 02 machine? ...
Just so so ……
可能是我期望值太高吧…… 学习了,谢谢分享!
页:
[1]